If you are working on telephone solutions, please check
out the Ozeki VoIP SIP SDK.|
It can be used to create VoIP client and server software.
A Note on Firewalls and SQL Server
Chris D. sends us this tip regarding the effect of firewalls on the connection.
We have not tested this yet - but thought we would pass on the advice.
After trying everything listed on this page, with no luck and spending a day
searching newsgroups, I finally, nailed the problem down to a hardware
firewall at the ISP. If your server is hosted with an ISP, as mine was,
doing the above may not be enough, depending on how the server itself is setup.
Go to command prompt and type netstat -a
Within the results you need to see if the box is listening on the ports you think.
In my case, the hardware firewall was preventing me from being able to connect.
The solution was to stop using dynamics ports and open up a static port.
To do this open up the SQL configuration manager. Click on protocols. Double
Click on TCP/IP Click on IP Addresses tab As mentioned in the above document,
0 means dynamic ports.
I found that by setting the static port, this solved my problem. Put an empty
string in the TCP Dynamic ports box Set the port you want to connect on in the
TCP port box. Do this for the net connections you have.
Connect to the SQL using:
Works great now.
Obviously, you should check out that doing do will not open you up to security
risks with your ISP, however, this was the solution that ended an 8 hour
hairpulling session and I thought I would pass it on, just in case I could one
day help someone else.
MSSQL Server 2008 Connection