Autoreply Database User installation guide
This guide gives you the steps to install the Autoreply Database User.
To start installing and configuring an Autoreply Database
User user, click the Add button in the top right-hand corner of
the Users and Applications panel on the right of the Management
Console. You can also add a user by clicking the Add new user or
application item in the Users and applications menu (Figure 1).
Figure 1 - Add new user or application
This will bring up an interface consisting of two panels.
The panel on the left contains a list of users that have been installed.
In the bar at the bottom of the page you can read how many users have been
installed. The panel on the right contains a list of users that can be
installed.
Each user in the left-hand panel is listed with a unique name (and the user
type stated in brackets).
Each user in the right-hand panel is listed with the name of its type and a
brief description of what it can be used for. To add an SMPP user, click the
Install link in the respective entry in the list (Figure 2).
Figure 2 - Install the user
Now provide a unique name for the user to be installed
(Figure 3).
Figure 3 - Provide a name for the user
The Configuration panel appears. If you are content
with the default settings you can leave this window unchanged and click on
"OK" (Figure 4).
Figure 4 - Logging tab
In Advanced tab you can specify the phone number
of the sender, and you can provide a username and a password to login.
In the lower section of this tab you can enable Allow routing table
override option. If routing table override is enabled,
this user can specify the preferred service provider connection for
each message. You can also enable Enable accounting for this user option.
If you enable accounting, a credit limit can be set for this user.
The user will not be allowed to send more messages then the credit limit.
Figure 5 - Advanced tab
Dig deeper!
People who read this also read...
Next page:
Create database layout
| 
